Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

forming 11mm gras

Post Reply
Message
Author
lamontagne0527
Member
Member
Posts: 70
Joined: Fri Jul 14, 2017 3:46 pm
Age: 26
Location: Ontario, Canada
Canada

forming 11mm gras

#1 Post by lamontagne0527 » Mon Apr 16, 2018 12:29 pm

Is it an easy process to form 11x59mm gras? I have been told 348 winchester is a good parent case but in Canada thats hard to come by, is it easy to form the brass from 50-110?

Is there a way to form the brass without the appropriate dies? Can i use a 45 acp sizer to form the neck and then fire form? There not much info online about forming these cases.

Post Reply

Return to “Reloading”

Who is online

Users browsing this forum: No registered users and 1 guest