Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.
1 post • Page 1 of 1
- Bullet Banger
- Posts: 662
- Joined: Mon Oct 23, 2017 11:27 pm
- Age: 84
- Location: USA, Colorado
OKAY - I just measured the grit size of the BON-AMI...it is fine stuff...so as far as I am concerned it is too fine for anything that I will use it for. For the smallest particles I get about 0.2 microns and for the largest I get about 0.5 microns...so I will call it about 0.5 micron grit compound.
NRA LIFE MEMBER
Who is online
Users browsing this forum: No registered users and 1 guest