http://www.scoutscopes.comhttp://www.mojosights.comhttp://smith-sights.com

It is currently Tue Feb 21, 2017 3:38 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sun Dec 18, 2016 12:51 pm 
Offline
Mil-Surp Collector
Mil-Surp Collector

Joined: Sat Jan 24, 2009 7:53 pm
Posts: 282
Location: Maryland
Age: 61
I just bought a custom model 70 pre 64 serial number 41,754 in 22 hornet and I would like to pick up a scope mount with rings for a balvar 6 - 24 power that i already have. It came with a one piece Redfield with the front ring that twists, and as I was trying to take it off, the front mounting screw stripped so I had to drill it out and the mount was ruined. The rear bridge has been tapped for an additional hole and the redfield mount that was used did not utilize it. The additional hole appears to be parallel with the rest of the screws.and as far as I can tell center to center is about .556 which is less than 128th of an inch shy of 9/16, i don't know how much wiggle room i would have if the mount holes don't align with the receiver holes exactly, so, should I just use the three factory holes and go with a one piece mount or should I chance using the additional hole with a two piece. I don't want a cheap set up and would like a set of rings that would give additional elevation for the newer Balvar if needed but it is not absolutey necessary because i probably won't be going beyond 200 yards with the 22 hornet


Attachments:
20161212_100239-1.jpg
20161212_100239-1.jpg [ 491.01 KiB | Viewed 1240 times ]

_________________
Member of Berwyn Rod and Gun Club since 1983, it is an outdoor range located in Bowie Maryland, if interested in joining call 301-261-7515 or 301-464-9830

You don't pay too much, you pay too soon
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group
FAIR USE NOTICE: This site may contain copyrighted material the use of which has not been pre-authorized by the copyright owner. Such material is made available to advance understanding of political, economic, scientific, social, art, media, and cultural issues. The 'fair use' of any such copyrighted material that may exist on this site is provided for under U.S. Copyright Law. In accordance with U.S. Code Title 17, Section 107, material on this site is distributed without profit to persons interested in such information for research and educational purposes. If you want to use any copyrighted material that may exist on this site for purposes that go beyond 'fair use', you must obtain permission from the copyright owner.