Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

DIY FWITW

Post Reply
Message
Author
OLDGUNNER
Bullet Banger
Bullet Banger
Posts: 631
Joined: Mon Oct 23, 2017 11:27 pm
Age: 84
Location: USA, Colorado
United States of America

DIY FWITW

#1 Post by OLDGUNNER » Mon Apr 02, 2018 1:24 pm

https://www.ebay.com/itm/3-Cross-Slide- ... SwSFZah56A
***********************************************
Of course this cheapy is not as handy and useful as a 500 $ Chiness Lathe, but most ‘guys’, well at least some, will not justify the expense of a lathe. This will fit nicely on a small drill press. Just make sure that the drill press will have a table that will tilt 90 degrees.
DSC_0007.JPG
NRA LIFE MEMBER

Post Reply

Return to “Fun Facts and Trivia”

Who is online

Users browsing this forum: No registered users and 3 guests