Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

First Attempt at Bullet Casting.

Post Reply
Message
Author
shoggoth80
Member
Member
Posts: 87
Joined: Mon Jun 05, 2017 4:13 am
Location: Seattle-ish, WA
United States of America

First Attempt at Bullet Casting.

#1 Post by shoggoth80 » Thu Jul 06, 2017 4:03 pm

Ok you guys... I'm hooked. Lol.
My friend and roommate has casting gear. I bought about a few pounds of lead ingots. Melted some down, used beeswax to separate dross, and cast up some minie ball. .54cal. There's some minor imperfections, but they seem shootable. I ordered my own .54cal minie mold, and a dual cavity .530 round ball mold. Got my own pot on wishlist, as well as .452 SWC mold. Still need a few molds to round out my calibers... But I'm seriously hooked on this. Good times.

Below are results of first attempts at casting. My buddy's pot needs some tweaking with the flow rate, but it's a start.
FB_IMG_1499370921213.jpg
FB_IMG_1499370914380.jpg
Last edited by shoggoth80 on Thu Jul 06, 2017 4:40 pm, edited 1 time in total.

User avatar
Ozzman
Junior Member
Junior Member
Posts: 46
Joined: Tue Jun 06, 2017 1:52 pm
Age: 36
Location: El Paso, Texas
United States of America

Re: First Attempt at Bullet Casting.

#2 Post by Ozzman » Thu Jul 06, 2017 4:34 pm

A whole new world has just opened up to you.
Start your research on the following:
- Bullet hardness and alloys for differing calibers (lead BHN values).
- Powder coated bullets
- 45-45-10 Bullet Lube
- Sizing dies
- Gas Checks
- Bullet Swaging & Dies

That should be enough for you to get going.
What is the definition of PROCRASTINATION?
"I'll tell you tomorrow"

shoggoth80
Member
Member
Posts: 87
Joined: Mon Jun 05, 2017 4:13 am
Location: Seattle-ish, WA
United States of America

Re: First Attempt at Bullet Casting.

#3 Post by shoggoth80 » Thu Jul 06, 2017 4:45 pm

Well for the muzzleloaders they're pure lead.
I've read a bit about Lyman #2 alloy, but haven't looked into the component metals. As I get the various molds I will. Lube will be a thing. I'm using bore butter on the mz rounds, but have heard various flavors talked about via YouTube. Tallow, beeswax, and oil for example. I'm a fan of DIY, so this fits right in.

Post Reply

Return to “Bullet Casting”

Who is online

Users browsing this forum: No registered users and 1 guest