Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.
6 posts • Page 1 of 1
Looking to attempt my first rust bluing project on an old pistol using Pilkington solution. The pistol has no collector value, but was a hand-me-down from an uncle. The metal is in decent shape with some minor pitting and surface rust. Much of the old blue has worn off. Any tips for using this system appreciated.
Be careful when filing/sanding, have a lot of patience, i did not use pilkingtons, i made my own solution and practiced on scrap,tools, and then a few old gun parts lying around. Apply solution very sparingly dont go over same spot do not rub. Apply in same direction every time. Do not be afraid of rust you just dont want pitting. Smooth velvety rust is what you want. When its orange or reddish boil in distilled water i let it boil 10- 20 mins. I used a number of things to card. A stainless steel wire toothbrush, 0000 steel wool, denim rags, and a jewelers wire wheel on my foredom tool. The wire wheel gave the best carding for a good shine. I just did my RIA 1911 pics posted in my been tinkering post under USpistols. Good luck Ernest T
Your welcome sir, I suspended the larger parts, the frame and slide, the smaller parts i used a steamer basket. Also the pot i boiled in and the basket are stainless steel. I am by no means an expert.
Who is online
Users browsing this forum: No registered users and 3 guests