Does anyone have experience with welding the AK47 flats? I have been given a couple of flats that look like they were laser cut and have tabs on them to keep them together when bent into shape. Then would need to be welded. What look like dark lines on the flat are the laser cut areas.
Thanks,
Pat
Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.
AK47 flats
-
- Junior Member
- Posts: 28
- Joined: Sun Oct 22, 2017 1:14 pm
- Age: 66
- Location: Illinois, USA
Re: AK47 flats
I welded my flat after bending it.
It was very easy and there are lots of tutorials online.
The rifle shoots good and operates flawlessly.
It was very easy and there are lots of tutorials online.
The rifle shoots good and operates flawlessly.
-
- Junior Member
- Posts: 28
- Joined: Sun Oct 22, 2017 1:14 pm
- Age: 66
- Location: Illinois, USA
Re: AK47 flats
Thanks for the reply. I'll look for the tutorials
Pat
Pat
Who is online
Users browsing this forum: No registered users and 4 guests