Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

Mauser Floorplate Release Button Tutorial

Post Reply
Message
Author
User avatar
Zeliard
Member
Member
Posts: 180
Joined: Sat Jun 03, 2017 10:27 pm
Age: 40
Location: Southeast US
United States of America

Mauser Floorplate Release Button Tutorial

#1 Post by Zeliard » Sun Aug 27, 2017 10:48 pm

Originally posted by odies dad.

I decided to do a tutorial on how to make floorplate release buttons.

Image

Start with a soft ¼” bolt with about ½” of unthreaded shank.

Image

Cut off the hex head. This is easy on a lathe but can be done with a file in a drill press.

Image

This is what you end up with.

Image

You can cut grooves for better traction or leave it plain. This part is pretty tough on a drill press but easy on a lathe. You could cut checkering or whatever you would like.

Image

Cut it off a little more than ½” from the head of the bolt.

Image

Image

This is what you end up with.

Image

Image

The hard part is drilling a hole to insert a retainer pin. A split pin works the best, but a stiff wire about 1/16”-5/64” will work. Drill a hole that will hold the wire snugly about 1/16” from the end of the pin. Cut a slot in the floorplate catch as shown wide enough for the retainer pin to clear.
The end of the button should be about flush with the top of the catch when it is released. If it is too short it can rattle. If it is too tight it will not release the catch completely.

Dip the pin in some cold bluing solution after you get it made.
Proud alumni of Transylvanian Polygnostic University. "Know enough to be afraid."

"Vertroue in God en die Mauser".-Faith in God and the Mauser.

"Send lawyers, guns and money." -Warren Zevon

Post Reply

Return to “General Gunsmithing”

Who is online

Users browsing this forum: No registered users and 3 guests