Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

A DIY penetrating fluid tests as the BEST of the BEST!

Post Reply
Message
Author
DaleH
Member
Member
Posts: 65
Joined: Sun Jun 04, 2017 9:24 pm
Age: 57
Location: Mass, USA
United States of America

A DIY penetrating fluid tests as the BEST of the BEST!

#1 Post by DaleH » Mon Aug 21, 2017 10:33 pm

This DIY penetrating fluid is the BEST of the BEST, as the best penetrating oil one can use can't be bought ... but you can easily make it yourself as a DIY homemade mix. Kroil may be good, but this mix tests out to be TWICE as good! Just use a mix of 50% acetone and 50% automatic transmission fluid (ATF).

'Machinist Workshop Magazine" did a test on penetrating oils. Using nuts and bolts that they ‘scientifically rusted’ to a uniform degree by soaking in salt water, they then tested the break-out torque required to loosen the nuts. They treated the nuts with a variety of penetrants and measured the torque required to loosen them.

This is what they came up with:
  • Nothing: 516 lbs
  • WD-40: 238 lbs
  • PB Blaster: 214 lbs
  • Liquid Wrench: 127 lbs
  • Kano Kroil: 106 lbs
  • ATF/Acetone mix (50/50 mix): 50 lbs

Post Reply

Return to “General Gunsmithing”

Who is online

Users browsing this forum: No registered users and 1 guest