Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

WZ-1970 Air Pistol Disassembly and reassembly help

Post Reply
Message
Author
User avatar
Kevinofborg
Member
Member
Posts: 105
Joined: Thu Jun 08, 2017 12:20 am
Age: 51
Location: Dallas, TX
United States of America

WZ-1970 Air Pistol Disassembly and reassembly help

#1 Post by Kevinofborg » Wed Aug 02, 2017 7:01 pm

I need some help with disassembly on this one ( I have search the net but not found what I need to get past this one).

Has anyone removed the piston? If you want to make a phone call PM me so we can set something up. I cannot figure it out.

Thanks,
Kevin
kevinofborg
TX

72 usmc
Member
Member
Posts: 184
Joined: Fri Jun 02, 2017 10:28 pm
Age: 66
Location: Menomonee Falls, Wi
United States of America

Re: WZ-1970 Air Pistol Disassembly and reassembly help

#2 Post by 72 usmc » Wed Aug 02, 2017 8:40 pm

Did you see this on how to make the seal?
http://anotherairgunblog.blogspot.com/s ... %20lucznik

a little on the piston here
https://www.gatewaytoairguns.org/GTA/in ... ic=45314.0

A review that shows the piston and some idea of how to remove but I do not have a manual nor did I ever buy a pistol
https://worap.wordpress.com/2016/11/09/ ... k-wz-1970/

source above
Removing the springs and piston is simple. With the pistol uncocked and discharged, the spring retaining cap at the base of the grip is unscrewed until it releases. There is relatively little tension on the springs, and these will project only around 1″ when the cap is removed so no special tools or precautions are required. With the cap removed, the springs, piston and sleeve can be extracted from the grip. Take care to note how the end of the trigger guard engages with the sleeve and piston assembly to ensure correct re-assembly.
To old to fight and to old to run, a Jar head will just shoot and be done with you.

Post Reply

Return to “General Firearms Topics”

Who is online

Users browsing this forum: No registered users and 11 guests