Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

Iver Johnson Safety hammerless 2nd Model

Post Reply
Message
Author
User avatar
Airforce1
Global Moderator
Global Moderator
Posts: 141
Joined: Fri Jun 02, 2017 7:53 pm
Age: 33
Location: Faribault, MN
United States of America

Iver Johnson Safety hammerless 2nd Model

#1 Post by Airforce1 » Tue Nov 27, 2018 4:20 am

I just got a box of "stuff" given to me for "disposal" because the people were not allowed by law to have anything. In this box is a lot of reloading components and old ammo but there was a couple of parts guns in there. One is a back half of an open break shotgun of unknown origin (ground dug and too rusted). The other was this, an old 2nd Model Iver Johnson .38 revolver. It is in very tight good condition just the usual flakey nickel rusty finish. Unfortunately it is missing the cylinder assembly and one grip is broken. This is the tightest frames I have seen in a while and would like to find the missing parts to get her going again. Anyone have anything laying around to help? Thanks.
Attachments
20181127_030707 (Medium).jpg
20181127_030659 (Medium).jpg
20181127_030602 (Medium).jpg
20181127_030551 (Medium).jpg

User avatar
Airforce1
Global Moderator
Global Moderator
Posts: 141
Joined: Fri Jun 02, 2017 7:53 pm
Age: 33
Location: Faribault, MN
United States of America

Re: Iver Johnson Safety hammerless 2nd Model

#2 Post by Airforce1 » Mon Dec 24, 2018 1:59 am

Picked up a pristine cylinder assembly on eBay for 34 dollars shipped. Listed the the hammer model but it fit perfectly and required no fitting. Not bad for a total of 34 dollars invested.
Attachments
20181222_202805 (Medium).jpg
20181222_202532 (Medium).jpg

indy1919a4
Gun Nut
Gun Nut
Posts: 915
Joined: Sat Jun 10, 2017 12:23 pm
Age: 56
Location: Indianapolis, Indiana
United States of America

Re: Iver Johnson Safety hammerless 2nd Model

#3 Post by indy1919a4 » Mon Dec 24, 2018 10:48 am

WOw, that is lucky.. any plans to fire it??

Post Reply

Return to “US Pistols”

Who is online

Users browsing this forum: No registered users and 2 guests