Page 1 of 1

Swiss Vetterli rounds dropping out bottom.

Posted: Sat May 11, 2019 9:58 am
by KneverKnew
I’ve noticed while test cycling rounds through the tube magazine that sometimes if I don’t pull bolt
To rear briskly enough to bring lifter to full top position that next next round in the tube will fall out the bottom of the lifter mechanism. Anyone else have this happen? Thoughts on the cause and a possible remedy?

Re: Swiss Vetterli rounds dropping out bottom.

Posted: Tue Jun 11, 2019 4:00 pm
by KneverKnew
Nobody has a clue?