Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.
2 posts • Page 1 of 1
- Tommy Atkins
- Global Moderator
- Posts: 630
- Joined: Sat Jun 03, 2017 4:47 pm
- Age: 66
- Location: Hagerstown, MD
Yes the new handguards & forend are slightly oversized to allow for individual fitting. Try carefully sanding the flat bottom/top where they meet, till the band fits. Then (if needed) the barrel channel & receiver bedding areas. Repeat in ever decreasing circles till it's "right". You may need to re-bed a little more elsewhere as well depending on how much fitting is needed.
Who is online
Users browsing this forum: No registered users and 4 guests