Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.

Type 38 Carbine Upper Handguard

Arisaka, Murata, Siamese, Korean, and North China Rifles
Post Reply
Message
Author
PatB
Registered User
Registered User
Posts: 9
Joined: Sun May 26, 2019 2:54 pm
Age: 69
Location: Fincastle VA
United States of America

Type 38 Carbine Upper Handguard

#1 Post by PatB » Mon Oct 21, 2019 9:31 am

Hello All. I am rebuilding a Type 38 carbine and need an upper hand guard. This piece is approximately 10.5 inches long. Does anyone know if the upper handguard for the full length Type 38 rifle is interchangeable with the carbine hand guard?

User avatar
vandle
Bullet Banger
Bullet Banger
Posts: 652
Joined: Sun Jun 04, 2017 6:08 pm
Age: 52
Location: Brisbane Australia
Australia

Re: Type 38 Carbine Upper Handguard

#2 Post by vandle » Fri Oct 25, 2019 12:27 am

Unfortunately they are not interchangeable
Life is tough, tougher if your stupid

"The world is a dangerous place to live; not because of the people who are evil, but because of the people who don't do anything about it." Albert Einstein

PatB
Registered User
Registered User
Posts: 9
Joined: Sun May 26, 2019 2:54 pm
Age: 69
Location: Fincastle VA
United States of America

Re: Type 38 Carbine Upper Handguard

#3 Post by PatB » Thu Oct 31, 2019 9:27 am

Thanks for the info. I’m still looking ...

Post Reply

Return to “Japanese and Far East Rifles”

Who is online

Users browsing this forum: No registered users and 3 guests