Well, the board is either fixed, or it's going to run terribly. Cross your fingers and hope for the best. I'm at my technical limit right now.
Search found 78 matches
- Sat May 12, 2018 3:25 pm
- Forum: United States Rifles
- Topic: 1903 A3 REAR SIGHT APERTURE MOVES.
- Replies: 3
- Views: 1137
There is a flat spring plate that is supposed to hold the sight in place. I was never able to rebend the spring to create more presure.As i recall I could not loosen the screw that held the plate down. I just replcaced the sight. I know that's not the best method, but I could not get to the spring t...
Only the receiver is numbered. Any other numbers are part numbers and you need an in-depth book that will give you want numbers belong in the era of the rifle manufacture. As for parts numbering to the gun serial....no. There were 4 makers of Garands, so one can often see their Garand has mixed manu...
Not a rifle problem! Your entire process is correct! Your final summation incorrect. Once you pull the bolt back, a TIGHT grabbing clip will hold the bolt back as the bolt face meets the cartridge. Then one usually heels the op-rod gently stripping the cartridge from the clip. One should roll the ha...
Here is a link where that page can be seen!